NEWS CENTER
Oasis Iceberg
13
2024
-
07
Closed cooling tower for injection molding machine
The injection molding machine is a common plastic injection molding equipment. It injects molten plastic material into the mold, cools and solidifies, and finally forms the required plastic products.
The injection molding machine is a common plastic injection molding equipment. It injects molten plastic material into the mold, cools and solidifies, and finally forms the required plastic products. In the injection molding process, it is necessary to use a cooling tower to control the temperature of the mold and injection molding machine to ensure that the plastic products have good quality and performance.
The closed cooling tower is a commonly used cooling device, which controls the temperature of the injection molding machine by circulating water. In a closed cooling tower, water is lifted from the bottom of the tower to the top of the tower through a pipe, and then evenly sprayed on the mold and related parts of the injection molding machine through a nozzle to achieve the purpose of reducing the temperature. At the same time, the hot water is recycled after cooling, which improves the utilization rate of cooling water.
1. Control the stability of temperature
The closed cooling tower can be adjusted according to the needs of the injection molding machine to ensure that the temperature is stable within an appropriate range. This is very important for the normal operation of the injection molding machine, and can avoid the problem of uneven plastic melting or poor cooling caused by too high or too low temperature.
2. Improve production efficiency
The closed cooling tower can effectively reduce the operating temperature of the injection molding machine and improve production efficiency. Lower temperatures can speed up the cooling of the plastic, thereby shortening the injection cycle and increasing production.
3. Save energy
The closed cooling tower uses circulating water for cooling, which saves a lot of cooling water resources compared to the traditional open cooling tower. At the same time, by optimizing the circulation and utilization of cooling water, energy consumption can be reduced and operating costs can be reduced.
4, increase the service life of the equipment
The closed cooling tower can effectively clean impurities and deposits in the cooling water, reduce corrosion and damage to the injection molding machine and mold, and extend the service life of the equipment.
Previous Page
Oasis Bingfeng Fluid Equipment Co.,Ltd
Contact Phone:+86 4000 616 676
Fax:+86 0310 3178005
E-mail:sales@hdbingfeng.com
Contact Address:No.1, Happiness Road, Feixiang Economic Development Zone, Handan City, Hebei Province
Copyright©2024 Oasis Bingfeng fluid equipment co., ltd